APPLICATION:
Control Panel included with the CP3800/T and CP3800/TL control systems.
DIMENSIONS:
Doors closed: 8.5W x 4.5H
Doors open: 12 3/8"W x 4.5H
INSTALLATION:
- Select a location inside the house or other weather-protected area to mount the Control Panel. The Control Panel is typically installed on a dry-wall between two studs. The average height is approximately 5 feet from the ground.
- Remove backplate from Control Panel. Position backplate and mark the three mounting points.
- Drill 3/16" diameter holes at the three points. Insert mounting anchors (included) into the three holes.
- Pull cable through large hole in backplate, use the three 1.25" screws to mount backplate to wall. Use crimping tool to connect modular connector to cable. See Modular Crimping Tool for details.
- Plug modular connector into either COM PORT socket on the back of the Control Panel.
- Mount Control Panel to backplate.
- At the Power Center, use the crimping tool to connect the modular connector to the cable. Plug modular connector into the COM PORT socket.
ADDING ADDITIONAL CONTROL PANELS:
For each additional Control Panel order part number CP-3800. The two connectors on the back of the Control Panel allows daisy chaining the communication cable. |
