APPLICATION:

High voltage relay kit for 2-speed filter pump.

SPECIFICATIONS:
TYPE: DPDT
AMPS: 20
PUMP: 3 HP MAX.

INSTALLATION:

1. At the LX Power Center, remove service panel from right-side compartment to expose high volatage section.
2. Remove wingnut from mounting stud of relay kit, and position relay below existing relays on compartment divider.
3. Loosen LOCK SCREW of hinged faceplate (left-side compartment), and swing it open to expose low voltage section.
4. Feed low voltage connector of relay through lower hole, and mounting stud through upper hole in compartment divider.
5. Plug low voltage connector into circuit board at appropriate relay socket.
6. Snap terminal block into next available position on mounting track in high voltage compartment. Push hard to secure.
7. Interconnect terminal block with LOAD 1 and LOAD 2 of R1(FLTR) terminal block, in accordance with diagram above.
8. Remove protective backing from DUAL SPEED label (included in relay kit), and adhere in appropriate position to cover the high voltage wiring label adjacent to terminal block.
9. Connect two speed filter pump to LOW SPEED, HIGH SPEED, and COMMON terminals at DUAL SPEED terminal block.