The In-House Remote allows you to independently set pool and spa water temperatures, program filter pump and auxiliary circuit start and stop times, manually start and stop the filter pump and auxiliary circuits, override timing cycles, and turn the heater off - all without going outdoors. It also monitors heater and system problems and repeats error messages which show on the heater control panel.

Note that the In-House Remote allows you to start, stop, and set cycle times on equipment and auxiliaries that have been programmed into the heater control box. It does not allow you to add or delete features. For example, if the heater is programmed with pool lights on the AUX 2 circuit, you can set up the timer cycle for the lights on the In-House Remote. However, you cannot add lights to the set-up at the Remote; this must be done at the control box.

Also, note that while the heater control box sets up cycle times on a 24-hour clock in terms of start time and duration (Start at 1200, run 3 hours), the In-House Remote sets up cycle times in terms of start and stop times (start at 12:15 pm, stop at 3:45 pm). This allows more flexibility, as you can set a cycle to start or stop at any time through the In- House Remote. The am/pm display automatically follows the clock time through all operations.